Slave Cylinder

REMOVAL & INSTALLATION

1972–84 Vehicles

1. Disconnect and plug the line at the cylinder.
2. On models through 1975, unhook the release lever return spring. On 1976 and later models, unhook the lever from the pushrod.
3. Remove the nuts and washers attaching the slave cylinder to the clutch housing.
4. Installation is the reverse of removal. Torque the mounting nuts to 12–17 ft. lbs. Fill and bleed the system.

1986 Vehicles

1. Raise and support the front end on jackstands.
2. Back off the flare nut on the fluid pipe to free the slave cylinder hose.
3. Pull off the hose-to-bracket retaining clip and pull the hose from the bracket. Cap the pipe to prevent fluid loss.
4. Unbolt and remove the slave cylinder.
5. Installation is the reverse of removal. Torque the bolt to 12–17 ft. lbs.