Previous Next

Ignition Switch

REMOVAL & INSTALLATION

1982–84 Vehicles
  1. Disconnect the negative battery terminal.
  2. Remove the steering wheel.
  3. Remove the steering column shroud.
  4. Disconnect the multiple connectors at the base of the combination switch.
  5. Remove the switch retaining snapring. Pull the turn signal indicator canceling cam off the shaft.
  6. Remove the switch retaining bolt and remove the complete switch from the column.
  7. Installation is the reverse of removal.
1986 Vehicles

Fig. 1: Ignition switch used on the 1986 models

  1. Disconnect the battery ground cable.
  2. Remove the steering column covers.
  3. Disconnect the wiring harness connector at the switch.
  4. Remove the attaching screw and lift out the switch.
  5. Installation is the reverse of removal.

Previous Next