DISARMING THE ANTI-THEFT SYSTEM

NOTE: Perform Steps 1–3 within 10 seconds or the disarming procedure will be canceled and you will have to start over. Also, Step 4 must be completed within 10 seconds of completing Steps 3 or the procedure will be canceled and you will have to start over at Step 1.

WARNING
Three consecutive errors, including turning the ignition switch to OFF and disconnecting the audio unit, will activate the anti-theft system and render the unit completely inoperative. If this occurs, you must contact your vehicle manufacturer.

1. Turn the ignition switch to the accessory (ACC) position and turn off the audio unit.
2. Press and hold the SCAN and AUTO-M buttons simultaneously for approximately 1.5 seconds until the word CODE appears on the display.
3. Press the SCAN and AUTO-M buttons again until bars (–) appear on the display.
4. Use channel buttons 1–4 to input the current code number. Press button 1 for the first digit, 2 for the second, etc. (if your code were 2321, you would press button 1 three times to display, 0, 1, then 2 followed by pressing button 2 four times to display 0, 1, 2 then 3 and so on). If at any point during the input of the code the display is deleted, you must start over at Step 1.
5. With the code number displayed, press and hold the SCAN and AUTO-M buttons for approximately 1.5 seconds until a beep is heard. The word CODE will be displayed for about 5 seconds. After it disappears, the code number is canceled.