Camshaft Followers

Removal & Installation

To Remove:

1. Remove the valve cover.
2. Turn the camshaft so the valve lash adjuster you are removing is on the camshaft lobe base circle.
3. Use the valve spring compressor tool (303-523) to compress and hold the valve and valve spring.
4. Remove the roller finger follower.
5. Remove the hydraulic lash adjuster, if needed.

To Install:

1. Lubricate the points of the roller finger follower with the correct type of grease.
2. If removed, install the lash adjuster in the bore.
3. Use the valve spring compressor tool (303-523) to compress and hold the valve spring.
4. Install the roller finger follower over the hydraulic lash adjuster and the valve stem.
5. Release the tension on the valve spring.
6. Install the valve cover.