Speed Control Actuator Switch

Removal & Installation

To Remove:

1. Disconnect the negative battery cable.
2. Remove the steering wheel.
3. Remove the steering wheel rear cover by first removing the screws then the cover.
4. Remove the ribbon harness from the clips.
5. Remove the horn contact electrical connectors.
6. Remove the right side horn contact by first removing the screws, then the contact.
7. Remove the speed control actuator switch assembly by first removing the screws, then removing the assembly.

To Install:

1. Install the speed control actuator switch assembly. Tighten to 4.8-5.5 ft-lb (6.5-7.5 Nm).
2. Install the right side horn contact. Tighten to 58-66 in-lb (6.5-7.5 Nm).
3. Install the horn contact electrical connectors.
4. Install the ribbon harness.
5. Install the steering wheel rear cover and screws.
6. Install the steering wheel.
7. Connect the negative battery cable.