Speed Control Cable

Removal & Installation

To Remove:

1. Remove the bolts and accelerator control splash shield.
2. Remove the speed control actuator cable bolt.
3. Separate the speed control actuator cable from the throttle body linkage.
4. To remove the speed control actuator cable from the speed control servo, press the speed control actuator locking clip inward then turn the actuator counterclockwise.

To Install:

NOTE: The rubber seal must be completely seated.

1. Install the cable into the nesting slot.
2. Lock the cable ball slug into the slot located in the servo rotor.

   NOTE: Be sure the white indicator mark can be seen on the speed control actuator cable for correct routing.

3. Pull the cable tight at the throttle body end.
4. Align and insert the cap into the slots in the servo body.
5. Rotate the cap clockwise until the locking arm on the cap engages the tab on the servo.
6. Snap the speed control actuator cable onto the throttle body linkage.

   CAUTION
   The guide pin has to be completely seated before you install the speed control actuator cable bolt.

7. Install the speed control actuator cable bolt. Tighten to 27-38 in-lb (3.1-4.3 Nm).
8. Install the accelerator control splash shield by correctly positioning the shield, then installing the bolts.