Previous Next

Brake Disc

Removal & Installation

Front

To Remove:

  1. Remove the front disc brake caliper anchor plate.
  2. On 4x4 vehicles ONLY: Remove the brake disc.
  3. On 4x2 vehicles ONLY: Remove the brake disc and hub.
  4. If necessary on 4x2 vehicles, resurface the brake disc and hub.

To Install:

  1. On 4x4 vehicles ONLY: Clean the brake disc then place it on the wheel hub.
  2. On 4x2 vehicles ONLY: Clean and examine the front wheel bearings and the brake disc and hub. Next, lubricate the front wheel bearings with the correct type of grease and install a new wheel hub grease seal then install the brake disc and hub.
  3. Tighten the spindle nut as you turn the brake disc and hub. Torque to 21 ft-lb (28 Nm).
  4. Loosen the spindle nut by turning counterclockwise 175°.
  5. Tighten the spindle nut while rotating the brake disc and hub. Torque to 17 in-lb (2 Nm).
  6. On 4x2 vehicles ONLY: Install the nut retainer, cotter pin, and hub grease cap.
  7. Install the front disc brake caliper anchor plate.

Previous Next