To Remove:
NOTE: Be sure the parking brake control is completely released.
- Relieve the tension on the parking brake system by pulling down on the parking brake intermediate cable, then inserting a 5/32 in (4 mm) drill bit in the parking brake control.
- Remove the left-hand front fender apron.
NOTE: Disconnect the front parking brake cable and conduit at the end of the connector with the locating hole.
- Disconnect the front parking brake cable and conduit from the parking brake intermediate cable.
- Remove the front parking brake cable and conduit from the bracket.
- Remove the parking brake release mounting bolts.
- Remove the parking brake control and front parking brake cable and conduit.
To Install:
- Install the parking brake control and front parking brake cable and conduit. Torque parking brake control bolts to 13-17 ft-lb (17-23 Nm).
- Install the parking brake release mounting bolts. Torque to 19-25 in-lb (2.1-2.9 Nm).
- Install the front parking brake cable and conduit to the bracket.
- Connect the front parking brake cable and conduit to the parking brake intermediate cable.
- Install the left-hand fender apron.
- Slightly depress the parking brake and remove the drill bit.
- Make sure the parking brake is operating correctly.
