Water Pump

Removal & Installation

To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Disconnect the negative battery cable.
3. Remove the air cleaner outlet pipe.
4. Drain the cooling system.
5. Remove the drive belt.
6. Remove the bolts and water pump pulley.
7. Remove the water pump.

NOTE: Lubricate the water pump O-ring, with clean coolant.

To Install:

1. Install the water pump.
   • Torque to 89 in-lb (10 Nm).
2. Install the water pump pulley.
   • Torque to 18 ft-lb (25 Nm).
3. Install the drive belt.
4. Fill the cooling system.
5. Install the air cleaner outlet pipe.
6. Connect the negative battery cable.
7. Start the vehicle and check for leaks, repair if necessary.