To Remove:
- Remove the bolts and accelerator control splash shield. Next, disconnect the speed control cable by first disconnecting the cable from the throttle lever then pressing the tabs and separating the speed control cable from the intake manifold.
- Remove the speed control cable cap from the speed control actuator by pushing in the locking arm on the cap and turning the cap counterclockwise.
- Remove the speed control cable by pressing the spring retainer then sliding the core wire end out of the speed control actuator pulley and removing the speed control cable.
To Install:
NOTE: The rubber seal must be completely seated onto the speed control cap.
- Install the speed control cable.
- Install the speed control cable cap.
- Connect the speed control cable then install the accelerator control splash shield and bolts.
