Removal & Installation

To Remove:

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Disconnect the negative battery cable.
3. Remove the accessory drive belt.
4. Remove the nut.
5. Disconnect the electrical connectors.
6. Remove the wiring harness-to-generator push pin.
7. Remove the bolts and the generator.

To Install:

1. Install the generator and bolts.
   • Torque to 35 ft-lb (47 Nm).
2. Install the wiring harness-to-generator push pin.
3. Reconnect the electrical connectors.
4. Install the nut and the accessory drive belt.
5. Reconnect the negative battery cable.