Flywheel Ring Gear (M/T)

Removal & Installation

To Remove:

WARNING
Use tongs and heat resistant gloves to prevent injury from hot material.

CAUTION
Do not heat the ring gear more then 500°F (260°C). Use a heat indicating crayon to determine correct temperature.

1. Remove the flywheel from the engine.
2. Heat the ring gear evenly with a torch to cause the ring gear to expand.
3. Use a brass drift and hammer to remove the ring gear from the flywheel.

To Install:

1. Heat the new ring gear evenly with a torch to cause the ring gear to expand.
2. Install the ring gear on the flywheel with the bevel facing the rear of the flywheel.
3. Heat and tap the ring gear as needed until installed squarely on the flywheel.
4. Install the flywheel on the engine.