Multi-function Switch

Removal & Installation

To Remove:

1. Disconnect the negative battery cable.
2. Remove the ignition lock cylinder.
3. If present, remove the tilt wheel handle.
4. Remove the upper and lower steering column shrouds.
5. Remove the multi-function switch.

To Install:

1. Install the multi-function switch.
   • Torque to 27 in-lb (3 Nm).
2. Install the upper and lower steering column shrouds.
3. If present, install the tilt wheel handle.
4. Install the ignition lock cylinder.
5. Connect the negative battery cable.