REMOVAL & INSTALLATION

All Models

1. Loosen the accessory being driven and move it on its pivot point to free the belt.
2. Remove the belt. If an idler pulley is used, it is often only necessary to loosen the idler pulley to provide enough slack to remove the belt.

   To install:

3. After the new belt is in place and properly tensioned, start the engine and allow it to run for about five minutes to seat the new belt.
4. Stop the engine and recheck the belt tension. Adjust as necessary.

   NOTE: On engines with many driven accessories, other belts may have to be removed to access the one being replaced.