The transfer pump is an impeller type pump. On 626s and MX-6s, the pump is
mounted in the fuel tank next to the main fuel pump. On 323s, the pump is mounted
on a bracket on the underside of the fuel tank. The transfer pump generates
an output pressure of 0.4–5.7 psi (3–39 kPa).
- Disconnect the negative battery cable.
- On 323s, work from underneath the vehicle and separate the transfer pump
from the mounting bracket.
- On 626s and MX-6s, remove the fuel tank from the vehicle, then remove the
cover plate attaching screws and withdraw the pump from the fuel tank.
- Detach the fuel hoses and electrical connector from the pump.
To install:
- Attach the hoses and connectors to the pump.
- On 323s, connect the pump to the mounting bracket.
- On 626s and MX-6s, position the transfer pump in the fuel tank. Use a new
cover plate gasket and install the cover plate attaching screws. Properly
install the fuel tank.
- Connect the negative battery cable.
