Back-Up Light Switch

The back-up light switch is threaded into the transaxle case.

1. Remove the wire clamp from the transaxle case that secures the switch wire.
2. Detach the electrical wiring multi-connector.
3. Loosen and remove the switch from the transaxle case.
4. Remove the metal gasket from the switch.

   To install:

5. Position a new gasket on the switch.
6. Thread the switch into the transaxle case and tighten it just enough to crush the gasket.
7. Connect the wiring, install the wire clamp and check that the switch operates properly.