CLUTCH RELEASE CABLE

Rear Wheel Drive GLC

Loosen the locknut and put tension on the outer cable (pull, do not push) while turning the adjusting nut until the clearance shown in the illustration is 0.06–0.09 in. (1.5–2.3mm). Then, tighten the locknut.

Front Wheel Drive GLC

1. Loosen the locknut on the end of the clutch cable, near the release lever. (The release lever is mounted on top of the transaxle case.)
2. Turn the adjusting nut until the gap (clearance) between the roller on the cable and the release lever is 0.08–0.12 in. (2–3mm).

   NOTE: In order to get an accurate measurement, be sure to pull the roller toward the end of the cable while pushing the lever in the opposite direction.

3. Tighten the locknut.