LEVEL CHECK

1. Drive the vehicle for several miles to bring the fluid level to operating temperature.
2. Park the truck on a level surface.
3. Put the automatic transmission in PARK. Leave the engine running.
4. Remove the dipstick from the tube and wipe it clean.
5. Reinsert the dipstick so that it is fully seated.
6. Remove the dipstick and note the reading. If the fluid is at or below the Add mark, add sufficient fluid to bring the level to the Full mark. Do not overfill the transmission. Overfilling will lead to fluid aeration.

   Fig. 1: Automatic transmission fluid level dipstick is located on the right side of the engine in the rear of the compartment — MPV shown

   Fig. 2: Automatic transmission fluid level dipstick measurement-Fluid level should be between the two arrows

   Fig. 3: Use a funnel (to avoid spills) and add the required type and amount of ATF