OIL LEVEL CHECK

When checking the oil level, it is best that the oil be at operating temperature, although checking the level immediately after stopping will give a false reading because all of the oil will not have drained back into the crankcase. Be sure that the truck is on a level surface, allowing tine for all of the oil to drain back into the crankcase.

1. Open the hood and locate the engine oil dipstick.
2. Remove the dipstick and wipe it clean with a rag.

   Fig. 2: Oil level dipstick measurement

   Fig. 3: Pour the engine oil, using a funnel, through the oil fill hole located on the right side valve cover — MPV

3. Insert the dipstick fully into the tube and remove it again. Hold the dipstick horizontal and read the level on the dipstick. The level should be between the F (Full) and L (Low) marks. If the oil level is at or below the L mark, sufficient oil should be added to restore the level to the proper place. Oil is added through the capped opening in the top of the valve cover. See the section on "Oil and Fuel Recommendations'' for the proper viscosity and oil to use.
4. Replace the dipstick and check the level after adding oil. Be careful not to overfill the crankcase.