REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.
2. Disconnect the electrical harness connector from the coil pack.
3. Remove the spark plug wires by squeezing the locking tabs to release the coil boot retainers.
4. Remove the coil pack retaining bolts and remove the coil pack.
5. Place the coil pack in position and install the retaining bolts. Tighten the bolts to 40–62 inch lbs. (4.5–7.0 Nm).

   NOTE: Be sure to place some dielectric compound into each spark plug boot prior to installation of the spark plug wire.