- Run the Self-Test for the output system being used: Super Star II, analog
voltmeter, or dash light.
- When the service codes start to be displayed the codes will be cleared when
the Test button is unlatched on the Super Star II tester. For the other retrieval
methods the codes will be cleared when the jumper is removed between the Self-Test
Input connector and the Signal Return pin of the Self-Test connector.
- Disconnect the Super Star II tester or voltmeter.
The Keep Alive Memory will be erased when the negative battery cable is disconnected.
Keep the cable off for a minimum of 5 minutes. When the cable is connected and
the vehicle driven, it may exhibit some drivability problems for the first 10
miles (16 km) or so. This is due to the relearning process where the ECA memorizes
values needed for optimum drivability.
