- Disconnect the wiring from the harness.
- Remove the sensor hold-down bolt and remove the sensor from the axle.
To install:
- Thoroughly clean the mounting surfaces. Make sure no dirt falls into the
axle. Clean the magnetized sensor pole piece. Metal particles can cause sensor
problems. Replace the O-ring.
- Coat the new O-ring with clean engine oil.
- Position the new sensor on the axle. It should slide into place easily.
Correct installation will allow a gap of 0.005–0.045 inch.
- Torque the hold-down bolt to 25–30 ft. lbs. (34–41 Nm).
- Connect the wiring.
