- Remove the seat anchor bolts.
- Lift out the seat.
- Installation is the reverse of removal.
| Fig. 1: Pickup seat removal/installation
|
- Remove the fuel filler lid opener.
- Remove the parking brake lever.
- Remove the seat bracket covers.
- Remove the seat leg covers.
- Remove the seat bracket-to-floor bolts and lift out the seat.
- Installation is the reverse of removal. Torque the bracket-to-floor bolts
to 38 ft. lbs. (52 Nm).
| Fig. 2: MPV front seat components
|
- Remove the jack cover.
- Remove the jack and jack handle.
- Remove the seat bracket covers.
- Remove the seat leg covers.
- Remove the seat bracket-to-floor bolts and lift out the seat.
- Installation is the reverse of removal. Torque the bracket-to-floor bolts
to 38 ft. lbs. (52 Nm).
The seat is removed by simply unlatching the release levers on the seat legs.
| Fig. 3: Rear no. 1 seat components
|
- Remove the seat bracket cover.
- Remove the folding link bolts.
- Remove the rear hinge bolts.
- Remove the front hinge bolts.
- Lift out the seat.
- Installation is the reverse of removal. Torque all bolts to 22 ft. lbs.
(30 Nm).
| Fig. 4: Rear seat no. 2 and seat mount removal/installation
|
- Remove the 4 seat track-to-floorpan screws (2 each side) and lift the seat
and track assembly from the vehicle.
- To remove the seat tracks from the seat cushion, position the seat upside
down on a clean bench.
- Disconnect the latch tie rod assembly and assist spring from the tracks.
- Remove 4 track-to-seat cushion screws (2 each side) from the track assemblies.
Remove the tracks from seat cushion.
| Fig. 5: Navajo manual front seat removal/installation
|
To install:
- Position the tracks to the seat cushion. Install the 4 track-to-seat cushion
screws (2 each side) and tighten.
- Connect the latch tie rod assembly and assist spring to the tracks.
- Position the seat and track assembly in the vehicle.
- Install 4 track-to-floorpan screws and tighten to specification.
