Previous Next

INSPECTION

Distributor Cap

Fig. 1: Inspection points for the distributor cap — note the square alignment locator which limits the cap to one installation position

  1. Wash the inside and outside surfaces of the cap with soap and water then dry it with compressed air.
  2. Inspect the cap for cracks, broken or worn carbon button, or carbon tracks. Also inspect the cap terminals for dirt and corrosion.
  3. Replace the cap if any of the above conditions are observed.
Distributor Rotor

Fig. 2: Inspection points for the distributor rotor — note that some rotors have a locating boss which fits in the armature

  1. Wash the rotor with soap and water then dry with it compressed air.
  2. Inspect the rotor for cracks, carbon tracks, burns or damage to the blade or spring.
  3. Replace the rotor if any of the above conditions are observed.

Previous Next