When removing spark plug wires, use great care. Grasp and twist the insulator back and forth on the spark plug to free the insulator. Do not pull on the wire directly as it may become separated from the connector inside the insulator.
| Fig. 1: Note that the spark plug wires and distributor
cap are numbered for correct wiring placement at the factory (C refers
to ignition coil wire)
|
| Fig. 2: Be sure to number all the spark plug wires to
the correct terminal on the distributor cap before disconnecting them
|
| Fig. 3: Using a spark plug wire removal tool
|
To install:
NOTE: Whenever a high tension wire is removed for any reason form a spark plug, coil or distributor terminal housing, silicone grease must be applied to the boot before it is reconnected. Using a small clean tool, coat the entire interior surface of the boot with silicone grease or an equivalent.
