REMOVAL & INSTALLATION

Navajo and B Series Pick-up Models

1. Disconnect the negative battery cable.
2. Label and detach all wiring from the ignition coil.
3. Remove the ignition coil-to-bracket bolts, then remove the ignition coil.
4. If necessary, at this time the radio ignition interference capacitor can be removed from the ignition coil.

   To install:

5. If necessary, install the radio interference capacitor onto the ignition coil. Tighten the mounting bolt to 25–35 inch lbs. (2.8–4.0 Nm).
6. Position the ignition coil onto the mounting bracket, then install and tighten the mounting bolts to 25–35 inch lbs. (2.8–4.0 Nm).
7. Attach all wiring to the ignition coil, then connect the negative battery cable.

MPV Models

NOTE: The ignition coil on 1996–98 MPV models is an integral component of the distributor and cannot be serviced separately. If service is required the distributor must be replaced.

1. Disconnect the negative battery cable.
2. Disconnect the distributor lead and wiring harness.
3. Remove the 2 ignition coil mounting bracket bolts.
4. Remove the ignition coil from the vehicle.
5. Install in reverse order.