REMOVAL & INSTALLATION

1. Disconnect the negative battery cable.

   Fig. 1: To remove the TP sensor, first disconnect the wire harness plug from the sensor

   Fig. 2: If the mounting holes of the sensor are slotted, mark its position. Note: factory sensors are not slotted

2. Disengage the wiring harness connector from the TP sensor.
3. Remove the two TP sensor mounting screws, then pull the TP sensor out of the throttle body housing.

   Fig. 3: Remove the two attaching screws . . .

   Fig. 4: . . . then remove the sensor from the throttle body by lifting straight up to disengage the throttle blade (arrow)

   To install:

4. Position the TP sensor against the throttle body housing, ensuring that the mounting screw holes are aligned. When positioning the TP sensor against the throttle body, slide the sensor straight onto the housing.
5. Install and tighten the sensor mounting screws until snug.
6. Attach the wiring harness connector to the sensor, then connect the negative battery cable.