REMOVAL & INSTALLATION

The VSS is located half-way down the right-hand side of the transmission assembly.

1. Apply parking brake, block the rear wheels, then raise and safely support the front of the vehicle on jackstands.
2. From under the right-hand side of the vehicle, disengage the wiring harness connector from the VSS.
3. Loosen the VSS hold-down bolt, then pull the VSS out of the transmission housing.

   To install:

4. If a new sensor is being installed, transfer the driven gear retainer and gear to the new sensor.
5. Ensure that the O-ring is properly seated in the VSS housing.
6. For ease of assembly, engage the wiring harness connector to the VSS, then insert the VSS into the transmission assembly.
7. Install and tighten the VSS hold-down bolt to 62–88 inch lbs. (7–10 Nm).
8. Lower the vehicle and remove the wheel blocks.