REPLACEMENT

Fuse Panel

Located inside the passenger compartment, under the drivers-side of the instrument panel.

1. Turn the ignition switch OFF.

   Fig. 1: Location of the interior fusebox under the driver side dashboard — MPV

   To access the fuses, remove the fuse panel cover. Note the spare fuses (A) and provided fuse puller tool (B) — Navajo and B Series Pick-up

2. If equipped, remove the fuse panel access cover.
3. If equipped, remove the fuse puller tool from the cover. Using the provided tool or a pair of pliers, grasp the fuse and pull it from the panel

4. Grasp the push-in type fuse with the provided tool, or a pair of needle-nose pliers.
5. Look through the side of the fuse body to determine if the fuse element is blown.

   To install:

6. Check the amperage rating of the fuse which was removed and obtain a new fuse of the same rating.

   WARNING
   Never replace a blown fuse with a new fuse of a higher rating. Severe electrical damage, as well as possible electrical fire could result.

7. Align the fuse with its mounting position and push it into place until fully seated in the panel.
8. Turn the ignition switch on and operate the accessory that was protected by that fuse.

   WARNING
   If the fuse continues to blow, inspect and test the wire harness and component or components which are protected by that fuse.

Power Distribution Box

Located under the hood, in the engine compartment. It houses the fuses and relays for most of the under hood components which are not controlled by a dash mounted switch (such as the alternator, fuel pump, ECM, etc.). The fuses and relays are replaced in the same manner as the fuse panel inside the vehicle. The power distribution box cover is hinged on one end and utilizes a retaining latch on the other. Simply release the latch and lift the cover up to gain access to the fuses and relays.