Rear Speed Sensor

TESTING

Navajo and B Series Pick-up

1. Remove the rear wheel speed sensor from the axle housing.
2. Connect a Digital Volt/Ohm Meter (DVOM) across the two sensor terminals and record the reading.
3. The reading should be between 0.9 and 2.5k Ohms.
4. If not, replace the sensor.

MPV

1. Disconnect the speed sensor wire harness plug from the sensor or sensor pigtail.
2. Connect a Digital Volt/Ohm Meter (DVOM) across the two sensor terminals and record the reading.
3. The reading should be within 1.4–1.8k Ohms.
4. If not, replace the sensor.